20D-Link DSL-124 Wireless N300 ADSL2+ Modem Router User Manual
Section 3 - Getting Started
Step 4: Congure Wireless Network
This step of the wizard allows you to configure your Wireless network settings.
By default, wireless is enabled. If you want to disable the DSL-124’s wireless capability,
uncheck Enable Your Wireless Network.
Under Wireless Network Name (SSID) you can change the SSID of your wireless
network, for easier identification by wireless clients. If Visibility Status is set to Visible,
this name will show up when a client in range scans for wireless networks. Otherwise, if
your network is Invisible, clients will have to enter the SSID in order to connect.
Choose the best security level that is compatible with your wireless clients. WPA2-PSK
is recommended. Unless you chose None (this is NOT recommended), you will need to
enter a key below.
WPA/WPA2 Pre-Shared Key - Wireless clients requesting a connection with the network
will need to enter this key in order to connect.
Click Next to continue.
To Next Page
Loading...
