DSL-2640U Wireless ADSL2+ Router with Ethernet WAN Support
User Manual
Overview
Figure 2. Back panel view.
Port Description
DSL
A DSL port to connect the router to the telephone line.
LAN 1-4
4 Ethernet ports to connect Ethernet devices. One port can be used to
connect to a private Ethernet line.
WPS
A button to set up a wireless connection (the WPS function).
To use the WPS function: with the device turned on, push the button and
immediately release it. The WPS LED should start blinking.
WIRELESS
ON/OFF
A button to enable/disable the router's wireless network.
ON/OFF
A button to turn the router on/off.
12VDC IN
Power connector.
The RESET button located on the bottom panel of the router is designed to restore the factory
default settings. To restore the factory defaults, push the button (with the device turned on), hold it
for 10 seconds, and then release the button.
The device is also equipped with an external non-detachable Wi-Fi antenna.
Page 12 of 174
To Next Page
Loading...
Need help?
Power
Data Transfer Rates
