DSL-2640U Wireless ADSL2+ Router with Ethernet WAN Support
User Manual
Configuring via Web-based Interface
3.)"
On the Firewall / URL Filter page, you can specify restrictions on access to certain web sites.
Figure 116. The Firewall / URL Filter page.
To enable the URL filter, in the General Settings section, move the Enable switch to the right,
then select the needed mode from the Type drop-down list:
• Block listed URLs: when this value is selected, the router blocks access to all addresses
specified in the Filters section;
• Block all URLs except listed: when this value is selected, the router allows access to
addresses specified in the Filters section and blocks access to all other web sites.
Click the APPLY button.
To specify URL addresses to which the selected filtering mode will be applied, in the Filters
section, click the ADD button and enter a relevant address in the displayed line. Then click the
APPLY button.
To remove an address from the list of URL addresses, click the Delete icon ( ) in the line of the
relevant URL address. Then click the APPLY button.
Page 151 of 174
To Next Page
Loading...
Need help?
Power
Data Transfer Rates
