DSL-2640U Wireless ADSL2+ Router with Ethernet WAN Support
User Manual
Configuring via Web-based Interface
"3
On the System / Firmware Update page, you can update the firmware of the router and
configure the automatic check for updates of the router's firmware.
!
Update the firmware only when the router is connected to your PC via a wired
connection.
Figure 118. The System / Firmware Update page.
The current version of the router's firmware is displayed in the Current firmware version field.
By default, the automatic check for the router's firmware updates is enabled. If a firmware update is
available, a notification will be displayed in the top right corner of the page.
To disable the automatic check for firmware updates, in the Remote update section, move the
Check for updates automatically switch to the left and click the APPLY SETTINGS button.
To enable the automatic check for firmware updates, in the Remote update section, move the
Check for updates automatically switch to the right and click the APPLY SETTINGS button.
By default, in the Remote server URL field, the D-Link update server address
(fwupdate.dlink.ru) is specified.
You can update the firmware of the router locally (from the hard drive of your PC) or remotely
(from the update server).
Page 155 of 174
To Next Page
Loading...
