D-Link DSL-X1852E User Manual

54D-Link DSL-X1852E User Manual
Section 4 - Conguration
Network
Router Settings
Router IP Address: Enter the IP address of the router to be identied in your local network.
The default IP address is 192.168.1.1.
If you change the IP address, once you click Save, you will need
to enter the new IP address in your browser to get back into the
conguration utility.
Subnet Mask: Enter the subnet mask of this interface. The default subnet mask is
255.255.255.0.
Click Save when you are done or click Advanced Settings.
Advanced Settings
DHCP Server Settings
Disable DHCP
Server:
Select this option to disable the DHCP server. No further conguration
is available. If you choose to disable the router's DHCP server, there
should be other DHCP server on your network or you must congure
the LAN devices' IP addresses manually.
Enable DHCP
Server:
Select this option to enable the DHCP server.
Enter the following settings to congure your DHCP server:
DHCP IP
Address Range:
Specify the start and end IP addresses for the range of addresses to
be assigned by your router.
This section allows you to change the local network settings of the router
and to congure the DHCP settings. Go to Settings > Network to access this
page.

D-Link DSL-X1852E Specifications

General

Brand	D-Link
Model	DSL-X1852E
Category	Network Router
Language	English