D-Link DSL-X1852E User Manual

69D-Link DSL-X1852E User Manual
Section 4 - Conguration
ACL
The Access Control List (ACL) page allows you to enable or disable various
services of the router to be used within the LAN or from the WAN side. To
access this page, go to Features > ACL. To start enforcing the ACL, click
Activated.
Access Control Setup
ACL Rule Index: Select the rule index from the drop-down menu.
Active Enable or disable this particular access rule. Enable means the
particular service can be accessed by the specied IP address range.
Disable means the particular service cannot be accessed by the
specied IP address range.
Source IP Address: Enter the IP address range to apply the rule to. Only addresses in the
specied range have the permission to access this router with the
below application. Enter 0.0.0.0 to allow any IP address to access the
router.
Application: Select a pre-dened service: Web, Telnet, Ping or All for all of the
above services.
Interface: Select the interface from the drop-down menu to apply this access
rule: Both, WAN, or LAN. For Telnet, only LAN is available.
Note: The default ACL for web access IP range - 0.0.0.0~0.0.0.0 (any IP address) on the LAN
interface cannot be deleted or modied.
Click Add when you are done or Delete to remove the selected rule. Up to 4
rules can be created.

D-Link DSL-X1852E Specifications

General

Brand	D-Link
Model	DSL-X1852E
Category	Network Router
Language	English