D-Link DSL-X1852E - Page 87

81D-Link DSL-X1852E User Manual
Section 4 - Conguration
G.723 Speed: Select the speed for the G.723 audio codec: 5.3 or 6.3 kbit/s.
Pincode Enable: Enable or disable the use of pin code before making calls. If Enabled,
enter the pin code below.
P2P Enable: Enable or disable Peer-to-Peer (P2P) communication.
Line Conguration
The router features two phone ports, each of which can be congured independently to
convert voice trac into data packets for transmission over an IP network. Congure the
following audio codecs for both VoIP1 and VoIP2 lines. Select the encoding mode which
denes the encoding rate control parameters for each of the following audio codec for both
VoIP1 and VoIP2 lines.
G.722: Select the mode for the codec (0~7). The default is 1.
G.711 a-law: Select the mode for the codec(0~7). The default is 2.
G.711 u-law:: Select the mode for the codec (0~7). The default is 3.
G.729: Select the mode for the codec (0~7). The default is 4.
G.723: Select the mode for the codec (0~7). The default is 0.
ptime setup Select the packetization time (ptime): 10, 20, or 30.
Digit Map Enable: Enable or disable the digital map. If enabled, input the digit map in
the text box below.