D-Link DWR-111 - Failover Setting

24D-Link DWR-111 User Manual
Section 3 - Conguration
Failover Setting
This option can be set to either Load Sharing or
to Failover. With Load Sharing, the data usage is
distributed evenly over the two different Internet
connections. With Failover, the secondary Internet
connection will be in standby mode, until the primary
Internet connection fails.
This option should be set to an external IP address that
can be used to ensure that the 3G/4G LTE connection
will be kept from going oine due to inactivity. An
example would be Google’s public DNS servers (8.8.8.8
or 8.8.4.4) or your Internet service providers DNS servers.
This will automatically be set to the connection type
selected during the Internet connection Setup Wizard,
or set to the My Internet Connection is option which
is found on the Manual Internet Connections settings
page.
This can be set by clicking on Add New Rule, the
available options will be shown in the drop down box
that appears.
Click Save Settings to save your changes, or click Don’t
Save Settings to discard your changes.
Failover Type:
Remote Host for
Keep Alive:
Primary WAN:
Secondary WAN:
This connection can serve as a backup for your default connection.