D-Link DWR-111 - Routing

37D-Link DWR-111 User Manual
Section 3 - Conguration
RIP SETTING
Select this box to enable routing.
RIPv1: Protocol in which the IP address is routed
through the Internet.
RIPv2: Enhanced version of RIPv1 with added
features such as Authentication, Routing Domain,
Next Hop Forwarding, and Subnet-mask Exchange.
ROUTING RULES
Identies the rule.
Enter the IP of the specied network that you want
to access using the static route.
Enter the subnet mask to be used for the specied
network.
Enter the gateway IP address of the specified
network.
Enter the amount of hops it will take to reach the
specied network.
Select this box to enable the rule.
Click Save Settings to save your changes, or click
Don’t Save Settings to discard your changes.
Routing
RIP:
ID:
Destination:
Subnet Mask:
Gateway:
Hop:
Enable:
The Routing page allows you to specify custom routes that determine how data is moved around your network.