D-Link DWR-111 - SNMP

36D-Link DWR-111 User Manual
Section 3 - Conguration
SNMP
Select Enabled to allow local SNMP administration.
Sel ec t Disabled to disa llow l ocal SN MP
administration.
S e l ec t E na bl ed t o al l o w r e mot e SN M P
administration. Select Disabled to disallow remote
SNMP administration.
Enter the password public in this eld to allow “Read
only” access to network administration using SNMP.
You can view the network, but no conguration is
possible with this setting.
Enter the password private in this eld to gain
“Read and Write” access to the network using SNMP
software.
Enter up to four IP addresses of any trap targets on
your network.
Select the SNMP version of your system.
Remote IP address that can be used to access the
device for management via SNMP.
Click Save Settings to save your changes, or click
Don’t Save Settings to discard your changes.
SNMP
SNMP Local:
SNMP Remote:
Get Community:
Set Community:
IP 1, IP 2, IP 3, IP 4:
SNMP Version:
WAN Access IP
Address:
SNMP (Simple Network Management Protocol) is a widely used network monitoring and control protocol that reports activity on each network device
to the administrator of the network. SNMP can be used to monitor trac and statistics of the DWR-111. The DWR-111 supports SNMP v1 or v2c.