D-Link DWR-961 - IPv6 Prefix Settings

43D-Link DWR-961 User Manual
Section 3 - Conguration
prex1/prex2
Enabled Click this to enable or disable the following prex-specic ags.
prex Enter the network prex or the address of the interface.
AdvOnLinkFlag Indicates that this prex can be used for on-link determination.
Click to set this to on.
AdvAutonomousFlag Indicates that this prex can be used for autonomous address
conguration. Click to set this to on.
AdvValidLifetime The length of time (in seconds) that the prex will be valid for
the purpose of on-link determination. Enter either an integer or
the word innity.
AdvPreferredLifetime The length of time (in seconds) that addresses generated
from the prex via stateless address autoconguration remain
preferred. Enter either an integer or the word innity.
AdvRouterAddr When set, indicates that the address of the interface will be sent
instead of the network prex. Click this to set it to on.
If6to4 If an IPv4 address is entered, the prex will be combined with the
IPv4 address to produce a valid 6to4 prex. This option allows
systems with dynamic IPv4 addresses to update their advertised
6to4 prexes by restarting RADVD or by sending a signal to
cause RADVD to recongure itself.