D-Link DXS-1210 Series Hardware Installation Guide

DXS-1210 Series 10 Gigabit Ethernet Smart Managed Switch Hardware Installation Guide
16
Logging into the CLI
At the login screen, enter the Username and Password and press Enter after each entry to access the CLI.
DXS-1210-28T 10 Gigabit Ethernet Smart Managed Switch
Command Line Interface
Firmware: Build 1.00.009
Copyright(C) 2020 D-Link Corporation. All rights reserved.
User Access Verification
Username:admin
Password:*****
Switch#
NOTE: For security reasons, it is highly recommended to configure a personal username and password
for this Switch.
Creating a User Account
To create a new user account, use the username command in the Global Configuration Mode.
Switch# configure terminal
Switch(config)# username NewUser password 12345
Switch(config)#
A user account with the username 'NewUser' and password '12345' was created.
NOTE: Usernames can be up to 32 characters in length. Passwords can be up to 32 plain-text
characters in length. Passwords are case sensitive.
Configuring the IP Address
To configure the IP address of the Switch, use the ip address command in the VLAN Interface Configuration Mode.
Switch# configure terminal
Switch(config)# interface vlan 1
Switch(config-if)# ip address 10.50.50.50 255.0.0.0
Switch(config-if)#
The IP address of the Switch was change to '10.50.50.50' with the subnet mask of '255.0.0.0'.

D-Link DXS-1210 Series Specifications

General

Product Series	DXS-1210
Power Supply	Internal
Jumbo Frame Support	9KB
Number of Ports	12
Layer	L2+
Form Factor	Rack-mountable
Uplink Ports	10G SFP+
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C