D-Link DXS-3326GSR - Page 113

DXS-3326GSR Stackable Gigabit Layer 3 Switch
Command Parameters
config bandwidth_control [<portlist> | all] {rx_rate [no_limit | <value 1-999>] | tx_rate
[no_limit <value 1-999>]}
show bandwidth_control {<portlist>}
config scheduling <class_id 0-6> {max_packet <value 0-15>}
show scheduling
config 802.1p user_priority {<priority 0-7> <class_id 0-6>}
show 802.1p user_priority
config 802.1p
default_priority
[<portlist> | all] | <priority 0-7>
show 802.1p
default_priority
{<portlist>}
config
scheduling_mechanism
[strict | weight_fair]
show
scheduling_mechanism
enable hol_prevention
disable hol_prevention
show hol_prevention
Each command is listed, in detail, in the following sections.
config bandwidth_control
Purpose Used to configure bandwidth control on a by-port basis.
Syntax
config bandwidth_control [<portlist> | all] {rx_rate [no_limit |
<value 1-999>] | tx_rate [no_limit | <value 1-999>]}
Description
The config bandwidth_control command is used to configure
bandwidth on a by-port basis.
Parameters
<portlist> − Specifies a range of ports to be configured. The port
list is specified by listing the lowest switch number and the
beginning port number on that switch, separated by a colon.
Then the highest switch number, and the highest port number of
the range (also separated by a colon) are specified. The
beginning and end of the port list range are separated by a dash.
For example, 1:3 specifies switch number 1, port 3. 2:4 specifies
switch number 2, port 4. 1:3-2:4 specifies all of the ports between
switch 1, port 3 and switch 2, port 4 − in numerical order.
all – Choose this parameter to select all configurable ports.
rx_rate − Specifies that one of the parameters below (no_limit or
<value 1-999>) will be applied to the rate at which the above
specified ports will be allowed to receive packets
 no_limit − Specifies that there will be no limit on the rate
105