D-Link DXS-3326GSR - DNS Relay Commands

DXS-3326GSR Stackable Gigabit Layer 3 Switch
35
DNS RELAY COMMANDS
The DNS relay commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
config dnsr {[primary | secondary] nameserver <ipaddr> | [add | delete]
static <domain_name 32> <ipaddr>}
enable dnsr {cache | static}
disable dnsr {cache | static}
show dnsr {static}
Each command is listed, in detail, in the following sections.
config dnsr
Purpose Used to configure the DNS relay function.
Syntax
config dnsr {[primary | secondary] nameserver <ipaddr> |
[add | delete] static <domain_name 32> <ipaddr>}
This command is used to configure the DNS relay function on
the Switch.
Parameters
primary − Indicates that the IP address below is the address of
the primary DNS server.
secondary − Indicates that the IP address below is the address
of the secondary DNS server.
nameserver <ipaddr> − The IP address of the DNS nameserver.
[add | delete] – Indicates if the user wishes to add or delete the
DNS relay function.
<domain_name 32> − The domain name of the entry.
<ipaddr> − The IP address of the entry.
Restrictions Only administrator-level users can issue this command.
Description
Example Usage:
To set IP address 10.43.21.12 of primary.
DXS-3326GSR:4#config dnsr primary 10.43.21.12
Command: config dnsr primary 10.43.21.12
Success
288