D-Link DXS-3326GSR - Link Aggregation Commands

DXS-3326GSR Stackable Gigabit Layer 3 Switch
16
LINK AGGREGATION COMMANDS
The link aggregation commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
create
link_aggregation
group_id <value 1-32> {type [lacp | static]}
delete
link_aggregation
group_id <value 1-32>
config
link_aggregation
group_id <value1-32> {master_port <port> | ports <portlist> state
[enable | disable]}
config
link_aggregation
algorithm
[mac_source | mac_destination | mac_source_dest | ip_source |
ip_destination | ip_source_dest]
{group_id <value 1-32> | algorithm}
config lacp_port <portlist> mode [active | passive]
show lacp_port {<portlist>}
show link_aggregation
Each command is listed, in detail, in the following sections.
create link_aggregation
Purpose Used to create a link aggregation group on the Switch.
Syntax
create link_aggregation group_id <value 1-32> {type [lacp |
static]}
Description This command will create a link aggregation group with a unique
identifier.
Parameters
<value 1-32> − Specifies the group ID. The Switch allows up to 32
link aggregation groups to be configured. The group number
identifies each of the groups.
type – Specify the type of link aggregation used for the group. If
the type is not specified the default type is static.


lacp – This designates the port group as LACP compliant.
LACP allows dynamic adjustment to the aggregated port
group. LACP compliant ports may be further configured (see
config lacp_ports). LACP compliant must be connected to
LACP compliant devices.
static – This designates the aggregated port group as
static. Static port groups can not be changed as easily as
LACP compliant port groups since both linked devices must
be manually configured if the configuration of the trunked
group is changed. If static link aggregation is used, be sure
that both ends of the connection are properly configured and
132