D-Link DXS-3326GSR - Page 141

DXS-3326GSR Stackable Gigabit Layer 3 Switch
create link_aggregation
that all ports have the same speed/duplex settings.
Restrictions Only administrator-level users can issue this command.
Example usage:
To create a link aggregation group:
DXS-3326GSR:4#create link_aggregation group_id 1
Command: create link_aggregation group_id 1
Success.
DXS-3326GSR:4#
delete link_aggregation group_id
Purpose Used to delete a previously configured link aggregation group.
Syntax
delete link_aggregation group_id <value 1-32>
Description This command is used to delete a previously configured link
aggregation group.
Parameters
<value 1-32> − Specifies the group ID. The Switch allows up to 32
link aggregation groups to be configured. The group number
identifies each of the groups.
Restrictions Only administrator-level users can issue this command.
Example usage:
To delete link aggregation group:
DXS-3326GSR:4#delete link_aggregation group_id 6
Command: delete link_aggregation group_id 6
Success.
DXS-3326GSR:4#
config link_aggregation
Purpose Used to configure a previously created link aggregation group.
Syntax
config link_aggregation group_id <value 1-32> {master_port
<port> | ports <portlist> | state [enable | disable]
Description This command allows you to configure a link aggregation group that
was created with the create link_aggregation command above.
133