D-Link DXS-3326GSR - IP Multicasting Commands

DXS-3326GSR Stackable Gigabit Layer 3 Switch
39
IP MULTICASTING COMMANDS
The IP multicasting commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
show ipmc cache {group <group>} {ipaddress <network_address>}
show ipmc {ipif <ipif_name 12> | [inactive | pim | dvmrp}
Each command is listed, in detail, in the following sections.
show ipmc cache
Used to display the current IP multicast forwarding cache.
Syntax
show ipmc cache {group <group>} {ipaddress
<network_address>}
Description This command will display the current IP multicast forwarding
cache.
Parameters
group <group> − The multicast group IP address.
ipaddress <network_address> − The IP address and netmask of
the source. You can specify the IP address and netmask
information using the traditional format or the CIDR format. For
example, 10.1.2.3/255.255.0.0 or 10.2.3.4/16.
Restrictions None.
Purpose
Usage Example:
To display the current IP multicast forwarding cache:
307