D-Link DXS-3326GSR - IGMP Snooping Commands

DXS-3326GSR Stackable Gigabit Layer 3 Switch
19
IGMP SNOOPING COMMANDS
The IGMP snooping commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
config igmp_snooping [<vlan_name 32> | all] {host_timeout <sec 1-16711450> |
router_timeout <sec 1-16711450> | leave_timer <sec 1-
6711450> state [enable | disable]}
config igmp_snooping
querier
[<vlan_name 32> | all] {query_interval <sec 1-65535> |
max_response_time <sec 1-25> | robustness_variable <value 1-
255> | last_member_query_interval <sec 1-25> | state [enable |
disable]}
enable igmp snooping {forward_mcrouter_only}
disable igmp snooping {forward_mcrouter_only}
config router_ports {vlan <vlan_name 32>} [add | delete] <portlist>
config
router_ports_forbidden
<vlan_name 32> [add | delete] <portlist>
show router_ports {<vlan_name 32>} {static | dynamic | forbidden}
show igmp_snooping {vlan<vlan_name 32>}
show igmp_snooping
group
{vlan <vlan_name 32>}
show igmp_snooping
forwarding
{vlan <vlan_name 32>}
Each command is listed, in detail, in the following sections.
config igmp_snooping
Purpose Used to configure IGMP snooping on the Switch.
Syntax
config igmp_snooping [<vlan_name 32> | all] {host_timeout
<sec 1-16711450> | router_timeout <sec 1-16711450> |
leave_timer <sec 1-16711450> | state [enable | disable]}
Description This command allows you to configure IGMP snooping on the
Switch.
Parameters
<vlan_name 32> − The name of the VLAN for which IGMP
snooping is to be configured.
all – Selecting this parameter will configure IGMP snooping for all
VLANs on the Switch.
host_timeout <sec 1-16711450> − Specifies the maximum
amount of time a host can be a member of a multicast group
without the Switch receiving a host membership report. The
default is 260 seconds.
147