D-Link DXS-3326GSR - ARP Commands

DXS-3326GSR Stackable Gigabit Layer 3 Switch
30
ARP COMMANDS
The ARP commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following
table.
Command Parameters
create arpentry <ipaddr> <macaddr>
delete arpentry [<ipaddr> | all]
show arpentry {ipif <ipif_name 12> | ipaddress <ipaddr> | static}
<value 0-65535>
clear arptable
config arp_aging time
Each command is listed, in detail, in the following sections.
create arpentry
Purpose Used to make a static entry into the ARP table.
Syntax
create arpentry <ipaddr> <macaddr>
Description This command is used to enter an IP address and the
corresponding MAC address into the Switch’s ARP table.
Parameters
<ipaddr> − The IP address of the end node or station.
<macaddr> − The MAC address corresponding to the IP address
above.
Only administrator-level users can issue this command. Restrictions
Example Usage:
To create a static ARP entry for the IP address 10.48.74.121 and MAC address 00:50:BA:00:07:36:
DXS-3326GSR:4#create arpentry 10.48.74.121 00-50-BA-00-07-
36
Command: create arpentry 10.48.74.121 00-50-BA-00-07-36
Success.
DXS-3326GSR:4#
delete arpentry
Purpose Used to delete a static entry into the ARP table.
Syntax
delete arpentry {<ipaddr> | all}
262