D-Link DXS-3326GSR - Route Redistribution Commands

DXS-3326GSR Stackable Gigabit Layer 3 Switch
33
ROUTE REDISTRIBUTION COMMANDS
The route redistribution commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
Command Parameters
create route redistribute
dst ospf src
[static | rip | local] {mettype [1 | 2] |metric <value 0-65535>}
create route redistribute
dst rip src
[local | static | ospf {all | internal | external | type_1 | type_2 |
inter+e1 | inter+e2}] {metric <value 0-65535>}
config route redistribute
dst ospf src
[static | rip | local] {mettype [1 | 2] | metric <value 0-65535>}
config route redistribute
dst rip src
[local | static | ospf {all | internal | external | type_1 | type_2 |
inter+e1 | inter+e2}] {metric <value 0-65535>}
delete route redistribute {dst [rip | ospf] src [rip | local | static | ospf]}
show route redistribute {dst [rip | ospf] | src [rip | static | local | ospf]
Each command is listed, in detail, in the following sections.
create route redistribute dst ospf src
Purpose Used to add route redistribution settings for the exchange of RIP
routes to OSPF routes on the Switch.
Syntax
create route redistribute dst ospf src [static | rip | local]
{mettype [1 | 2] | metric <value 0-65535>}
Description This command will redistribute routing information between the
OSPF and RIP routing protocols to all routers on the network that
are running OSPF or RIP. Routing information entered into the
Static Routing Table on the local DXS-3326GSR switch is also
redistributed.
Parameters
src [static | rip | local] − Allows for the selection of the protocol for
the source device.
mettype [1 | 2] − Allows for the selection of one of two methods of
calculating the metric value.
metric <value 0-65535> − Allows the entry of an OSPF interface
cost. This is analogous to a Hop Count in the RIP routing protocol.
Restrictions Only administrator-level users can issue this command.


Type-1 calculates (for RIP to OSPF) by adding the
destination’s interface cost to the metric entered in the Metric
field.
Type-2 uses the metric entered in the Metric field without
change. this field applies only when the destination field is
OSPF.
277