DXS-3326GSR Stackable Gigabit Layer 3 Switch
show iproute
Description This command will display the Switch’s current IP routing table.
Parameters
<network_address> − IP address and netmask of the IP interface
that is the destination of the route. You can specify the address
and mask information using the traditional format (for example,
10.1.2.3/255.0.0.0 or in CIDR format, 10.1.2.3/8).
static – Use this parameter to display static iproute entries.
rip – Use this parameter to display RIP iproute entries.
ospf – Use this parameter to display OSPF iproute entries.
Restrictions None.
Example Usage:
To display the contents of the IP routing table:
DXS-3326GSR:4#show iproute
Command: show iproute
IP Address/Netmask Gateway Interface Cost Protocol
--------------- --------------- --------------- ---- -----------
0.0.0.0 10.1.1.254 System 1 Default
10.0.0.0/8 10.48.74.122 System 1 Local
Total Entries: 2
DXS-3326GSR:4#
276
To Next Page
Loading...
