D-Link DXS-3326GSR - Switch Utility Commands

DXS-3326GSR Stackable Gigabit Layer 3 Switch
8
SWITCH UTILITY COMMANDS
The switch utility commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
download [firmware_fromTFTP <ipaddr> <path_filename 64> {image_id
<int 1-2>} {unit [all | <unitid 1-12>]} | cfg_fromTFTP <ipaddr>
<path_filename 64> {increment}]
config firmware image_id <int 1-2> [delete | boot_up]
show firmware information
upload [cfg_toTFTP <ipaddr> <path_filename 64> | log_toTFTP
<ipaddr> <path_filename 64>]
ping <ipaddr> {times <value 1-255>} {timeout <sec 1-99>}
traceroute <ipaddr> {ttl <value 1-60> | port <value 30000-64900> |
timeout <sec 1-65535> | probe <value <1-9>
Each command is listed, in detail, in the following sections.
download
Purpose Used to download and install new firmware or a switch
configuration file from a TFTP server.
Syntax
download [firmware_fromTFTP <ipaddr> <path_filename 64>
{image_id <int 1-2>} {unit [all | <unitid 1-12>]} | cfg_fromTFTP
<ipaddr> <path_filename 64> {increment}]
Description This command is used to download a new firmware or a switch
configuration file from a TFTP server.
Parameters
firmware_fromTFTP − Download and install new firmware on the
Switch from a TFTP server.




<ipaddr> − The IP address of the TFTP server.
<path_filename> − The DOS path and filename of the
firmware on the TFTP server. For example, C:\3226S.had.
image_id <int 1-2>- This Switch holds two places for
storing firmware, labeled 1 and 2. The user may store an extra
firmware file on the Switch for use at a later time. image_id 1
will hold the current firmware in use on the Switch. Not
specifying an image_id will automatically download the
firmware to image_id 1.
unit [all | <unitid 1-12>] − all specifies all units (switches) in
the switch stack, entering the <unitid 1-12> parameter will
specify the unit ID of the switch that will receive the download.
Entering this command without this parameter will download
the firmware directly to the DXS-3326GSR.
56