D-Link DXS-3326GSR - IGMP Commands

DXS-3326GSR Stackable Gigabit Layer 3 Switch
18
IGMP COMMANDS
The IGMP commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following
table.
Command Parameters
config igmp [ipif <ipif_name 12> | all} {version <value 1-2> | query_interval
<sec 1-65535> max_response_time <sec 1-25> |
robustness_variable <value 1-255> |
last_member_query_interval <value 1-25> | state [enable |
disable]}
show igmp {ipif <ipif_name 12>}
show igmp group {group <group>} {ipif <ipif_name 12>}
Each command is listed, in detail, in the following sections.
config igmp
Purpose Used to configure IGMP on the Switch.
Syntax
config igmp [ipif <ipif_name 12> | all] {version <value 1-2> |
{query_interval <sec 1-65535> | max_response_time <sec 1-
25> | robustness_variable <value 1-255> |
last_member_query_interval <value1-25> | state [enable |
disable]
Description This command allows you to configure IGMP snooping on the
Switch.
Parameters
<ipif_name 12> − The name of the IP interface for which you
want to configure IGMP.
all − Specifies all the IP interfaces on the Switch.
version <value 1-2> − The IGMP version number.
query_interval <sec 1-65535> − The time in seconds between
general query transmissions, in seconds.
max_response_time <sec 1-25> − Enter the maximum time in
seconds that the Switch will wait for reports from members.
robustness_variable <value 1-255> − This value states the
permitted packet loss that guarantees IGMP.
last_member_query_interval <value 1-25> − The Max Response
Time inserted into Group-Specific Queries sent in response to
Leave Group messages, and is also the amount of time between
Group-Specific Query messages.
The default is 1 second
state [enable | disable] − Enables or disables IGMP for the
specified IP interface.
Restrictions Only administrator-level users can issue this command.
144