DXS-3326GSR Stackable Gigabit Layer 3 Switch
34
BOOTP RELAY COMMANDS
The BOOTP relay commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
config bootp_relay {hops <value 1-16> | time <sec 0-65535>}
<ipif_name 12> <ipaddr>
config bootp_relay delete ipif <ipif_name 12> <ipaddr>
enable bootp_relay
disable bootp_relay
show bootp_relay {ipif <ipif_name 12>}
config bootp_relay add ipif
Each command is listed, in detail, in the following sections.
config bootp_relay
Purpose Used to configure the BOOTP relay feature of the Switch.
Syntax
config bootp_relay {hops <value 1-16>} {time <sec 0-
65535>}
This command is used to configure the BOOTP relay feature.
hops <value 1-16> − Specifies the maximum number of relay
agent hops that the BOOTP packets can cross.
time <sec 0-65535> − If this time is exceeded, the Switch will
relay the BOOTP packet.
Restrictions Only administrator-level users can issue this command.
Description
Parameters
Example Usage:
To configure bootp relay status.
DXS-3326GSR:4#config bootp_relay hops 4 time 2
Success.
Command: config bootp_relay hops 4 time 2
DXS-3326GSR:4#
config bootp_relay add
Purpose Used to add an IP destination address to the Switch’s BOOTP
To Next Page
Loading...
