D-Link DXS-3326GSR - OSPF Configuration Commands

DXS-3326GSR Stackable Gigabit Layer 3 Switch
41
OSPF CONFIGURATION COMMANDS
The OSPF configuration commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
Command Parameters
config ospf router_id <ipaddr>
enable ospf
disable ospf
<area_id> type [normal | stub {stub_summary [enable |
disable] | metric <value 0-65535>}]
delete ospf area <area_id>
config ospf area <area_id> type [normal | stub {stub_summary [enable |
disable] | metric <value 0-65535>}]
show ospf area {<area_id>}
<ipaddr> {area <area_id> | metric <value 1-65535>}
delete ospf host_route <ipaddr>
config ospf host_route <ipaddr> {area <area_id> | metric <value 1-65535>}
show ospf host_route <ipaddr>
create ospf aggregation <area_id> <network_address> lsdb_type summary {advertise
[enabled | disabled]}
delete ospf aggregation <area_id> <network_address> lsdb_type summary
config ospf aggregation <area_id> <network_address> lsdb_type summary {advertise
[enable | disable]}
show ospf aggregation <area_id>
show ospf lsdb {area <area_id> | advertise_router <ipaddr> | type [rtrlink |
netlink | summary | assummary | asextlink]}
show ospf neighbor <ipaddr>
show ospf
virtual_neighbor
{<area_id> <neighbor_id>}
config ospf ipif <ipif_name 12> {area <area_id> | priority <value> |
hello_interval <sec 1-65535 > | dead_interval <sec 1-65535> |
authentication [none | simple <password 8> | md5 <key_id 1-
255>] | metric <value 1-65535> state [enable | disable]
config ospf all {area <area_id> | priority <value> | hello_interval <1-65535
sec> | dead_interval <1-65535 sec> | authentication [none |
simple <password 8> | md5 <key_id 1-255>] | metric <value
1-65535> state [enable | disable]
show ospf
create ospf area
create ospf host_route
313