D-Link DXS-3326GSR - Page 286

DXS-3326GSR Stackable Gigabit Layer 3 Switch
Routing information source − RIP. the Static Route table, and the Local interface routing information. Routing information will
be redistributed to OSPF.
Route Source Metric Metric Type
RIP 0 to 16777214 mettype 1
mettype 2
Static 0 to 16777214 mettype 1
mettype 2
Local 0 to 16777214 mettype 1
mettype 2
Allowed Metric Type combinations are mettype 1 or mettype 2. The metric value 0 above will be redistributed in OSPF as the
metric 20.
Example Usage:
Command: create route redistribute dst ospf src rip
To add route redistribution settings:
DXS-3326GSR:4#create route redistribute dst ospf src rip
Success.
DXS-3326GSR:4#
create route redistribute dst rip src
Purpose Used to add route redistribution settings for the exchange of OSPF
routes to RIP routes on the Switch.
Syntax
create route redistribute dst rip src {all | internal | external |
type_1 | type_2 | inter+e1 | inter+e2}] {metric <value>}
This command will redistribute routing information between the
OSPF and RIP routing protocols to all routers on the network that
are running OSPF or RIP. Routing information entered into the
Static Routing Table on the local DXS-3326GSR switch is also
redistributed
src {all | internal | external | type_1 | type_2 | inter+e1 | inter+e2} −
Allows the selection of the protocol of the source device. The user
may choose between:
Description
Parameters

 internal – Specifies the internal protocol of the source
device.


all – Specifies both internal an external.
external - Specifies the external protocol of the source
device.
type_1 - Calculates the metric (for RIP to OSPF) by adding
the destination’s interface cost to the metric entered in the
278