DXS-3326GSR Stackable Gigabit Layer 3 Switch
create route redistribute dst rip src
Metric field.
type_2 - Uses the metric entered in the Metric field without
change. This field applies only when the destination field is
OSPF.
inter+e1 – Specifies the internal protocol AND type 1 of the
external protocol.
inter+e2 – Specifies the internal protocol AND type 2 of the
external protocol.
metric <value> − Allows the entry of an OSPF interface cost. This is
analogous to a HOP Count in the RIP routing protocol.
Restrictions Only administrator-level users can issue this command.
Routing information source − OSPF and the Static Route table. Routing information will be redistributed to RIP. The following
table lists the allowed values for the routing metrics and the types (or forms) of the routing information that will be redistributed.
Route Source Metric Type
OSPF 0 to 16
all
type_1
type_2
inter+e1
inter+e2
external
internal
Static 0 to 16 not applicable
Entering the Type combination − internal type_1 type_2 is functionally equivalent to all. Entering the combination type_1
type_2 is functionally equivalent to external. Entering the combination internal external is functionally equivalent to all.
Entering the metric 0 specifies transparency.
Example Usage:
To add route redistribution settings:
DXS-3326GSR:4#create route redistribute dst rip src ospf all metric 2
Command: create route redistribute dst rip src ospf all metric 2
Success.
DXS-3326GSR:4#
279
To Next Page
Loading...
