DXS-3326GSR Stackable Gigabit Layer 3 Switch
config route redistribute dst ospf src
Purpose Used configure route redistribution settings for the exchange of RIP
routes to OSPF routes on the Switch.
config route redistribute dst ospf src [static | rip | local]
{mettype [1 | 2] | metric <value 0-65535>}
Description
Route redistribution allows routers on the network − that are
running different routing protocols to exchange routing information.
This is accomplished by comparing the routes stored in the various
router’s routing tables and assigning appropriate metrics. This
information is then exchanged among the various routers according
to the individual routers current routing protocol. The Switch can
redistribute routing information between the OSPF and RIP routing
protocols to all routers on the network that are running OSPF or
RIP. Routing information entered into the Static Routing Table on
the local switch is also redistributed.
Parameters
src [static | rip | local] − Allows the selection of the protocol of the
source device.
mettype − allows the selection of one of the methods for calculating
the metric value.
metric <value 0-65535> − Allows the entry of an OSPF interface
cost. This is analogous to a Hop Count in the RIP routing protocol.
Restrictions Only administrator-level users can issue this command.
Syntax
Type-1 calculates the metric (for RIP to OSPF) by adding
the destination’s interface cost to the metric entered in the
Metric field.
Type-2 uses the metric entered in the Metric field without
change. This field applies only when the destination field is
OSPF.
Routing information source − RIP: the Static Route table, and the Local interface routing information. Routing information will
be redistributed to OSPF. The following table lists the allowed values for the routing metrics and the types (or forms) of the
routing information that will be redistributed.
Route Source Metric Metric Type
RIP 0 to 16777214 mettype 1
mettype 2
Static 0 to 16777214 mettype 1
mettype 2
Local 0 to 16777214 mettype 1
mettype 2
Allowed Metric Type combinations are mettype 1 or mettype 2. The metric value 0 above will be redistributed in OSPF as the
metric 20.
Example Usage:
To configure route redistributions:
280
To Next Page
Loading...
