D-Link DXS-3326GSR - Page 139

DXS-3326GSR Stackable Gigabit Layer 3 Switch
show gvrp
Parameters
<portlist> − Specifies a range of ports for which the GVRP status
is to be displayed. The port list is specified by listing the lowest
switch number and the beginning port number on that switch,
separated by a colon. Then the highest switch number, and the
highest port number of the range (also separated by a colon) are
specified. The beginning and end of the port list range are
separated by a dash. For example, 1:3 specifies switch number 1,
port 3. 2:4 specifies switch number 2, port 4. 1:3-2:4 specifies all
of the ports between switch 1, port 3 and switch 2, port 4 − in
numerical order.
Restrictions None.
Example usage:
To display GVRP port status:
1:11 1 Disabled Enabled All Frames
1:12 1 Disabled Enabled All Frames
1:14 1 Disabled Enabled All Frames
1:17 1 Disabled Enabled All Frames
DXS-3326GSR:4#show gvrp
Command: show gvrp
Global GVRP : Disabled
Port PVID GVRP Ingress Checking Acceptable Frame Type
------ ---- -------- ---------------- ---------------------------
1:1 1 Disabled Enabled All Frames
1:2 1 Disabled Enabled All Frames
1:3 1 Disabled Enabled All Frames
1:4 1 Disabled Enabled All Frames
1:5 1 Disabled Enabled All Frames
1:6 1 Disabled Enabled All Frames
1:7 1 Disabled Enabled All Frames
1:8 1 Disabled Enabled All Frames
1:9 1 Disabled Enabled All Frames
1:10 1 Disabled Enabled All Frames
1:13 1 Disabled Enabled All Frames
1:15 1 Disabled Enabled All Frames
1:16 1 Disabled Enabled All Frames
1:18 1 Disabled Enabled All Frames
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh
131