D-Link DXS-3326GSR - Page 120

DXS-3326GSR Stackable Gigabit Layer 3 Switch
config 802.1p default_priority
switch 1, port 3 and switch 2, port 4 − in numerical order.
all − Specifies that the config 802.1p default_priority command
will be applied to all ports on the Switch.
<priority 0-7> − Specifies the 802.1p priority tag that an untagged,
incoming packet will be given before being forwarded to its
destination.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure 802.1p default priority on the Switch:
DXS-3326GSR:4#config 802.1p default_priority all 5
Command: config 802.1p default_priority all 5
Success.
DXS-3326GSR:4#
show 802.1 default_priority
Purpose Used to display the currently configured 802.1p priority tags that
will be assigned to incoming, untagged packets before being
forwarded to its destination.
Syntax
show 802.1p default_priority {<portlist>}
Description
The show 802.1p default_priority command displays the
currently configured 802.1p priority tag that will be assigned to an
incoming, untagged packet before being forwarded to its
destination.
Parameters
<portlist> − Specifies a port or range of ports to be viewed. The
port list is specified by listing the lowest switch number and the
beginning port number on that switch, separated by a colon. Then
the highest switch number, and the highest port number of the
range (also separated by a colon) are specified. The beginning
and end of the port list range are separated by a dash. For
example, 1:3 specifies switch number 1, port 3. 2:4 specifies
switch number 2, port 4. 1:3-2:4 specifies all of the ports between
switch 1, port 3 and switch 2, port 4 − in numerical order.
Restrictions None.
Example usage:
To display the current 802.1p default priority configuration on the Switch:
112