DXS-3326GSR Stackable Gigabit Layer 3 Switch
config mirror delete
beginning and end of the port list range are separated by a
dash. For example, 1:3 specifies switch number 1, port 3. 2:4
specifies switch number 2, port 4. 1:3-2:4 specifies all of the
ports between switch 1, port 3 and switch 2, port 4 − in
numerical order.
rx − Allows the mirroring of only packets received by (flowing into)
the port or ports in the port list.
tx − Allows the mirroring of only packets sent to (flowing out of) the
port or ports in the port list.
both − Mirrors all the packets received or sent by the port or ports
in the port list.
Restrictions Only administrator-level users can issue this command.
Example usage:
To delete the mirroring ports:
DXS-3326GSR:4#config mirror port 1:5 delete source port 1:1-1:5 both
Command: config mirror 1:5 delete source 1:1-1:5 both
Success.
DXS-3326GSR:4#
enable mirror
Purpose Used to enable a previously entered port mirroring configuration.
Syntax
enable mirror
Description
This command, combined with the disable mirror command
below, allows you to enter a port mirroring configuration into the
Switch, and then turn the port mirroring on and off without having
to modify the port mirroring configuration.
Parameters None.
Restrictions None.
Example usage:
To enable mirroring configurations:
119
To Next Page
Loading...
