DXS-3326GSR Stackable Gigabit Layer 3 Switch
delete vlan
Switch.
Parameters
<vlan_name 32> − The VLAN name of the VLAN to delete.
Restrictions Only administrator-level users can issue this command.
Example usage:
To remove the vlan “v1”:
DXS-3326GSR:4#delete vlan v1
Command: delete vlan v1
Success.
DXS-3326GSR:4#
config vlan add
Purpose Used to add additional ports to a previously configured VLAN.
Syntax
config vlan <vlan_name 32> { [ add [ tagged | untagged |
forbidden ] <portlist> | advertisement [ enable | disable]}
Description This command allows you to add ports to the port list of a
previously configured VLAN. You can specify the additional ports
as tagging, untagging, or forbidden. The default is to assign the
ports as untagging.
Parameters
<vlan_name 32> − The name of the VLAN you want to add or
delete ports to.
add − Specifies which ports to add. The user may also specify if
the ports are:
tagged − Specifies the additional ports as tagged.
untagged − Specifies the additional ports as untagged.
forbidden − Specifies the additional ports as forbidden.
<portlist> − A range of ports to add to the VLAN. The port list is
specified by listing the lowest switch number and the beginning
port number on that switch, separated by a colon. Then the
highest switch number, and the highest port number of the range
(also separated by a colon) are specified. The beginning and end
of the port list range are separated by a dash. For example, 1:3
specifies switch number 1, port 3. 2:4 specifies switch number 2,
port 4. 1:3-2:4 specifies all of the ports between switch 1, port 3
and switch 2, port 4 − in numerical order.
advertisement [enable | disable] − Enables or disables GVRP on
the specified VLAN.
126
To Next Page
Loading...
