DXS-3326GSR Stackable Gigabit Layer 3 Switch
DXS-3326GSR:4#show link_aggregation
Command: show link_aggregation
Link Aggregation Algorithm = MAC-source-dest
Group ID : 1
Master Port : 2:17
Member Port : 1:5-1:10,2:17
Active Port:
Status : Disabled
Flooding Port : 1:5
DXS-3326GSR:4
config lacp_port
Purpose Used to configure settings for LACP compliant ports.
Syntax
config lacp_port <portlist> mode [active | passive]
Description This command is used to configure ports that have been
previously designated as LACP ports (see create
link_aggregation).
Parameters
<portlist> − Specifies a range of ports to be configured. The port
list is specified by listing the lowest switch number and the
beginning port number on that switch, separated by a colon. Then
the highest switch number, and the highest port number of the
range (also separated by a colon) are specified. The beginning
and end of the port list range are separated by a dash. For
example, 1:3 specifies switch number 1, port 3. 2:4 specifies
switch number 2, port 4. 1:3-2:4 specifies all of the ports between
switch 1, port 3 and switch 2, port 4 − in numerical order.
mode – Select the mode to determine if LACP ports will initially
send LACP control frames.
Restrictions Only administrator-level users can issue this command.
active – Active LACP ports are capable of processing and
sending LACP control frames. This allows LACP compliant
devices to negotiate the aggregated link so the group may be
changed dynamically as needs require. In order to utilize the
ability to change an aggregated port group, that is, to add or
subtract ports from the group, at least one of the participating
devices must designate LACP ports as active. Both devices
must support LACP.
passive – LACP ports that are designated as passive
cannot initially send LACP control frames, unless the port
receives LACP control frames. In order to allow the linked
port group to negotiate adjustments and make changes
dynamically, at one end of the connection must have “active”
LACP ports (see above).
136
To Next Page
Loading...
