DXS-3326GSR Stackable Gigabit Layer 3 Switch
enable igmp_snooping
Description This command allows you to enable IGMP snooping on the
Switch. If forward_mcrouter_only is specified, the Switch will
only forward all multicast traffic to the multicast router, only.
Otherwise, the Switch forwards all multicast traffic to any IP
router.
Parameters
forward_mcrouter_only − Specifies that the Switch should only
forward all multicast traffic to a multicast-enabled router.
Otherwise, the Switch will forward all multicast traffic to any IP
router.
Restrictions Only administrator-level users can issue this command.
Example usage:
To enable IGMP snooping on the Switch:
DXS-3326GSR:4#enable igmp_snooping
Command: enable igmp_snooping
Success.
DXS-3326GSR:4#
disable igmp_snooping
Used to enable IGMP snooping on the Switch.
disable igmp_snooping {forward_mcrouter_only}
Description This command disables IGMP snooping on the Switch. IGMP
snooping can be disabled only if IP multicast routing is not being
used. Disabling IGMP snooping allows all IGMP and IP multicast
traffic to flood within a given IP interface. If
forward_mcrouter_only is specified, the Switch will forward all
multicast traffic to any IP router.
Parameters
forward_mcrouter_only − Specifies that the Switch will forward all
multicast traffic to any IP router.
Restrictions Only administrator-level users can issue this command.
Purpose
Syntax
Example usage:
To disable IGMP snooping on the Switch:
150
To Next Page
Loading...
