D-Link DXS-3326GSR - Page 168

DXS-3326GSR Stackable Gigabit Layer 3 Switch
DXS-3326GSR:4#show mac_notification
Command: show mac_notification
Global Mac Notification Settings
State : Enabled
Interval : 1
History Size : 1
DXS-3326GSR:4#
show mac_notification ports
Used to display the Switch’s MAC address table notification status
settings
Syntax
show mac_notification ports <portlist>
Description This command is used to display the Switch’s MAC address table
notification status settings.
Parameters <portlist> - Specify a port or group of ports to be viewed. The port list
is specified by listing the lowest switch number and the beginning
port number on that switch, separated by a colon. Then the highest
switch number, and the highest port number of the range (also
separated by a colon) are specified. The beginning and end of the
port list range are separated by a dash. For example, 1:3 specifies
switch number 1, port 3. 2:4 specifies switch number 2, port 4. 1:3-
2:4 specifies all of the ports between switch 1, port 3 and switch 2,
port 4 − in numerical order.
Entering this command without the parameter will display the MAC
notification table for all ports.
Restrictions None
Purpose
Example usage:
To display all port’s MAC address table notification status settings:
DXS-3326GSR:4#show mac_notification ports
Command: show mac_notification ports
Port # MAC Address Table Notification State
------ ------------------------------------
1:1 Disabled
1:2 Disabled
1:3 Disabled
1:4 Disabled
1:5 Disabled
1:6 Disabled
1:7 Disabled
160