D-Link DXS-3326GSR - Page 172

DXS-3326GSR Stackable Gigabit Layer 3 Switch
Command Parameters
delete authen server_host <ipaddr> protocol [tacacs | xtacacs | tacacs+ | radius]
show authen server_host
<int 1-255>
config authen parameter
attempt
<int 1-255>
show authen parameter
enable admin
config admin local_enable <password 15>
config authen parameter
response_timeout
Each command is listed, in detail, in the following sections.
enable authen_policy
Purpose Used to enable system access authentication policy.
Syntax
enable authen_policy
Description This command will enable an administrator-defined authentication
policy for users trying to access the Switch. When enabled, the
device will check the method list and choose a technique for user
authentication upon login.
Parameters None.
Restrictions Only administrator-level users can issue this command.
Example usage:
To enable the system access authentication policy:
DXS-3326GSR:4#enable authen_policy
Command: enable authen_policy
Success.
DXS-3326GSR:4#
disable authen_policy
Purpose Used to disable system access authentication policy.
Syntax
disable authen_policy
Description This command will disable the administrator-defined authentication
policy for users trying to access the Switch. When disabled, the
Switch will access the local user account database for username and
password verification. In addition, the Switch will now accept the local
enable password as the authentication for normal users attempting to
164