D-Link DXS-3326GSR - Page 175

DXS-3326GSR Stackable Gigabit Layer 3 Switch
config authen_login
Parameters default – The default method list for access authentication, as defined
by the user. The user may choose one or a combination of up to four
(4) of the following authentication methods:
method_list_name – Enter a previously implemented method list
name defined by the user. The user may add one, or a combination of
up to four (4) of the following authentication methods to this method
list:
 tacacs – Adding this parameter will require the user to be
authenticated using the TACACS protocol from the remote
TACACS server hosts of the TACACS server group list.
 xtacacs – Adding this parameter will require the user to be
authenticated using the XTACACS protocol from the remote
XTACACS server hosts of the XTACACS server group list.
 tacacs+ – Adding this parameter will require the user to be
authenticated using the TACACS+ protocol from the remote
TACACS+ server hosts of the TACACS+ server group list.
 radius - Adding this parameter will require the user to be
authenticated using the RADIUS protocol from the RADIUS
server listed in the server group list.
 server_group <string 15> - Adding this parameter will require
the user to be authenticated using a user-defined server
group previously configured on the Switch.
 local - Adding this parameter will require the user to be
authenticated using the local user account database on the
Switch.
 none – Adding this parameter will require no authentication
to access the Switch.
 tacacs – Adding this parameter will require the user to be
authenticated using the TACACS protocol from a remote
TACACS server.
 xtacacs – Adding this parameter will require the user to be
authenticated using the XTACACS protocol from a remote
XTACACS server.
 tacacs+ – Adding this parameter will require the user to be
authenticated using the TACACS+ protocol from a remote
TACACS+ server.
 radius - Adding this parameter will require the user to be
authenticated using the RADIUS protocol from a previously
configured RADIUS server.
 server_group <string 15> - Adding this parameter will require
the user to be authenticated using a user-defined server
group previously configured on the Switch.
 local - Adding this parameter will require the user to be
authenticated using the local user account database on the
Switch.
167