D-Link DXS-3326GSR - Page 193

DXS-3326GSR Stackable Gigabit Layer 3 Switch
DXS-3326GSR:4# config authen parameter response_timeout 0
Command: config authen parameter response_timeout 0
Success.
DXS-3326GSR:4#
config authen parameter attempt
Purpose Used to configure the maximum number of times the Switch will
accept authentication attempts.
Syntax
config authen parameter attempt <int 1-255>
Description This command will configure the maximum number of times the
Switch will accept authentication attempts. Users failing to be
authenticated after the set amount of attempts will be denied
access to the Switch and will be locked out of further authentication
attempts. Command line interface users will have to wait 60
seconds before another authentication attempt. Telnet users will be
disconnected from the Switch.
Parameters parameter attempt <int 1-255> - Set the maximum number of
attempts the user may try to become authenticated by the Switch,
before being locked out. The default setting is 3 attempts.
Restrictions Only administrator-level users can issue this command.
Example usage:
To set the maximum number of authentication attempts at 5:
DXS-3326GSR:4#config authen parameter attempt 5
Command: config authen parameter attempt 5
Success.
DXS-3326GSR:4#
show authen parameter
Purpose Used to display the authentication parameters currently configured
on the Switch.
Syntax
show authen parameter
Description This command will display the authentication parameters currently
configured on the Switch, including the response timeout and user
authentication attempts.
This command will display the following fields:
185