D-Link DXS-3326GSR - Page 219

DXS-3326GSR Stackable Gigabit Layer 3 Switch
1:16 ForceAuth Success Authorized
1:19 ForceAuth Success Authorized
1:17 ForceAuth Success Authorized
1:18 ForceAuth Success Authorized
1:20 ForceAuth Success Authorized
CTRL+C ESC q Quit SPACE n Next Page Enter Next Entry a All
Example usage:
To display the 802.1x auth state for MAC-based 802.1x:
DGS-3324SRi:4#show 802.1x auth_state
Command: show 802.1x auth_state
Port number : 1:1
Index MAC Address Auth PAE State Backend State Port Status
------ ------------------- ----------------------- --------------------- -----------------
1 00-08-02-4E-DA-FA Authenticated Idle Authorized
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
CTRL+C ESC q Quit SPACE n Next Page Enter Next Entry a All
config 802.1x auth_mode
Purpose Used to configure the 802.1x authentication mode on the Switch.
Syntax
config 802.1x auth_mode {port_based | mac_based]
Description The config 802.1x authentication mode command is used to enable
either the port-based or MAC-based 802.1x authentication feature
on the Switch.
211