D-Link DXS-3326GSR - Page 22

DXS-3326GSR Stackable Gigabit Layer 3 Switch
show config
Purpose
Used to display a list of configuration commands entered into the
Switch.
Syntax show config [current_config | config_in_NVRAM]
Description
This command displays a list of configuration commands entered
into the Switch.
Parameters
current_config – Entering this parameter will display configurations
entered without being saved to NVRAM.
config_in_NVRAM - Entering this parameter will display
configurations entered and saved to NVRAM.
Restrictions
None.
Example usage:
To view configurations entered on the Switch that were saved to NVRAM:
Command: show config config_in_NVRAM
#------------------------------------------------------------------------------------------------------
# DXS-3326GSR Configuration
#
# Firmware: Build 3.00-B16
# Copyright(C) 2004-2007 Corporation. All rights reserved.
#---------------------------------------------------------------------------------------------------
# BASIC
config serial_port baud_rate 115200 auto_logout never
enable telnet 23
enable web 80
enable clipaging
# STORM
config traffic control 1:1-1:26 broadcast disable multicast disable dlf disable
threshold 128
config traffic control 2:1-2:24 broadcast disable multicast disable dlf disable
CTRL+C ESC q Quit SPACE n Next Page ENTER Next Entry a All
14