DXS-3326GSR Stackable Gigabit Layer 3 Switch
config access_profile
000000000000-FFFFFFFFFFFF
• 802.1p <value 0-7> − Specifies that the access profile will apply
only to packets with this 802.1p priority value.
• ethernet_type <hex 0x0-0xffff> − Specifies that the access
profile will apply only to packets with this hexadecimal 802.1Q
Ethernet type value in the packet header.
ip − Specifies that the Switch will look into the IP fields in each packet.
• vlan <vlan_name 32> − Specifies that the access profile will
apply to only to this VLAN.
• source_ip <ipaddr> − Specifies that the access profile will apply
to only packets with this source IP address.
• destination_ip <ipaddr> − Specifies that the access profile will
apply to only packets with this destination IP address.
• type <value 0-255> − Specifies that the access profile will
apply to this ICMP type value.
• dscp <value 0-63> − Specifies that the access profile will apply
only to packets that have this value in their Type-of-Service
(DiffServ code point, DSCP) field in their IP packet header.
• icmp − Specifies that the Switch will examine the Internet Control
Message Protocol (ICMP) field within each packet.
• code <value 0-255> − Specifies that the access profile will
apply to this ICMP code.
• igmp − Specifies that the Switch will examine the Internet Group
Management Protocol (IGMP) field within each packet.
• type <value 0-255> − Specifies that the access profile will
apply to packets that have this IGMP type value.
• tcp − Specifies that the Switch will examine the Transmission
Control Protocol (TCP) field within each packet.
• src_port <value 0-65535> − Specifies that the access profile
will apply only to packets that have this TCP source port in their
TCP header.
• dst_port <value 0-65535> − Specifies that the access profile
will apply only to packets that have this TCP destination port in
their TCP header.
• flag_mask – Enter the type of TCP flag to be masked. The
choices are:
• urg: TCP control flag (urgent)
• ack: TCP control flag (acknowledgement)
• psh: TCP control flag (push)
232
To Next Page
Loading...
