DXS-3326GSR Stackable Gigabit Layer 3 Switch
config access_profile
replace_dscp <value 0-63> − Allows you to specify a value to be
written to the DSCP field of an incoming packet that meets the criteria
specified in the first part of the command. This value will over-write the
value in the DSCP field of the packet.
deny – Specifies that packets that do not match the access profile are
not permitted to be forwarded by the Switch and will be filtered.
delete access_id <value 1-50> − Specifies the access ID of a rule you
want to delete.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure the access profile with the profile ID of 1 to filter frames that have IP addresses in the range between
10.42.73.0 to 10.42.73.255:
DXS-3326GSR:4# config access_profile profile_id 2 add access_id 1 ip
source_ip 10.42.73.1 deny
Success.
Command: config access_profile profile_id 1 add access_id 1 ip
source_ip 10.42.73.1 deny
DXS-3326GSR:4#
show access_profile
Purpose Used to display the currently configured access profiles on the
Switch.
Syntax
show access_profile
Description
The show access_profile command is used to display the
currently configured access profiles.
Parameters None.
Restrictions Only administrator-level users can issue this command.
Example usage:
To display all of the currently configured access profiles on the Switch:
234
To Next Page
Loading...
