D-Link DXS-3326GSR - Page 276

DXS-3326GSR Stackable Gigabit Layer 3 Switch
DXS-3326GSR:4#
Example usage:
To disable the virtual IP address from being pinged:
DXS-3326GSR:4#disable vrrp ping
Command: disable vrrp ping
Success.
DXS-3326GSR:4#
create vrrp vrid
Purpose To create a VRRP IP interface on the Switch.
Syntax
vrid <vrid 1-255> <ipif_name 12> ipaddress <ipaddr> {state
[enable | disable] | priority <int 1-254> | advertisement_interval
<int 1-255> | preempt [true | false] | critical_ip <ipaddr> |
critical_ip_state [enable | disable]}
Description This command is used to create a VRRP interface on the Switch.
Parameters vrid <vrid 1-255> - Enter a value between 1 and 255 to uniquely
identify this VRRP group on the Switch. All routers participating in
this group must be assigned the same vrid value. This value MUST
be different from other VRRP groups set on the Switch.
<ipif_name 12> - Enter the name of a previously configured IP
interface that you wish to create a VRRP entry for. This IP interface
must be assigned to a VLAN on the Switch.
priority <int 1-254> - Enter a value between 1 and 254 to indicate the
router priority. The VRRP Priority value may determine if a higher
priority VRRP router overrides a lower priority VRRP router. A higher
priority will increase the probability that this router will become the
Master router of the group. A lower priority will increase the
probability that this router will become the backup router. VRRP
routers that are assigned the same priority value will elect the
highest physical IP address as the Master router. The default value
is 100. (The value of 255 is reserved for the router that owns the IP
address associated with the virtual router and is therefore set
automatically.)
ipaddress <ipaddr> - Enter the virtual IP address that will be
assigned to the VRRP entry. This IP address is also the default
gateway that will be statically assigned to end hosts and must be set
for all routers that participate in this group.
state [enable | disable] – Used to enable and disable the VRRP IP
interface on the Switch.
advertisement_interval <int 1-255> - Enter a time interval value, in
seconds, for sending VRRP message packets. This value must be
consistent with all routers participating within the same VRRP group
268