D-Link DXS-3326GSR - Page 328

DXS-3326GSR Stackable Gigabit Layer 3 Switch
DXS-3326GSR:4#show ospf area
Command: show ospf area
Area Id Type Stub Import Summary LSA Stub Default Cost
-------------- ------------- ------------------------------------ ----------- --------
0.0.0.0 Normal None None None
10.48.74.122 Stub Enabled Enabled 1
Total Entries: 2
DXS-3326GSR:4#
create ospf host_route
Purpose Used to configure OSPF host route settings.
Syntax
create ospf host_route <ipaddr> {area <area_id> | metric
<value 1-65535>}
Description This command is used to configure the OSPF host route settings.
Parameters
<ipaddr> − The host’s IP address.
<area_id> − A 32-bit number in the form of an IP address
(xxx.xxx.xxx.xxx) that uniquely identifies the OSPF area in the
OSPF domain.
metric <value 1-65535> − A metric between 1 and 65535, which will
be advertised.
Restrictions Only administrator-level users can issue this command.
Usage Example
To configure the OSPF host route settings:
DXS-3326GSR:4#create ospf host_route 10.48.74.122 area 10.1.1.1 metric 2
Command: create ospf host_route 10.48.74.122 area 10.1.1.1 metric 2
Success.
DXS-3326GSR:4#
delete ospf host_route
Purpose Used to delete an OSPF host route.
Syntax
delete ospf host_route <ipaddr>
320