DXS-3326GSR Stackable Gigabit Layer 3 Switch
DXS-3326GSR:4#config ospf all state enable
Command: config ospf all state enable
Success.
DXS-3326GSR:4#
show ospf ipif
Used to display the current OSPF interface settings for the
specified interface name.
Syntax
show ospf ipif {<ipif_name 12>}
This command will display the current OSPF interface settings for
the specified interface name.
Parameters
<ipif_name 12> − The IP interface name for which you want to
display the current OSPF interface settings.
Restrictions None.
Purpose
Description
Usage Example
To display the current OSPF interface settings, for a specific OSPF interface:
DXS-3326GSR:4#show ospf ipif ipif2
Command: show ospf ipif ipif2
Interface Name: ipif2 IP Address: 123.234.12.34/24 ((Link Up)
Network Medium Type: BROADCAST Metric: 1
Area ID: 1.0.0.0 Administrative State: Enabled
Priority: 1 DR State: DR
DR Address: 123.234.12.34 Backup DR Address: None
Hello Interval: 10 Dead Interval: 40
Transmit Delay: 1 Retransmit Time: 5
Authentication: None
Total Entries: 1
DXS-3326GSR:4#
show ospf all
Purpose Used to display the current OSPF settings of all the OSPF
interfaces on the Switch.
Syntax
show ospf all
Description This command will display the current OSPF settings for all OSPF
To Next Page
Loading...
