D-Link DXS-3326GSR - Page 34

DXS-3326GSR Stackable Gigabit Layer 3 Switch
config ports
necessary for establishing the timing control between the two
physical layers. The timing control is set on a master physical
layer by a local source. The slave setting uses loop timing, where
the timing comes form a data stream received from the master. If
one connection is set for 1000 master, the other side of the
connection must be set for 1000 slave. Any other configuration will
result in a link down status for both ports.
flow_control [enable | disable] – Enable or disable flow control for
the specified ports.
learning [enable | disable] − Enables or disables the MAC address
learning on the specified range of ports.
state [enable | disable] − Enables or disables the specified range
of ports.
description <desc 32> - Enter an alphanumeric string of no more
than 32 characters to describe a selected port interface.
clear – Enter this command to clear the port description of the
selected port(s).
Restrictions
Only administrator-level users can issue this command.
Example usage:
To configure the speed of port 3 to be 10 Mbps, full duplex, learning and state enable:
DXS-3326GSR:4#config ports 1:1-1:3 speed 10_full learning
enable state enable
Command: config ports 1:1-1:3 speed 10_full learning enable
state enable
Success.
DXS-3326GSR:4#
show ports
Purpose
Used to display the current configuration of a range of ports.
Syntax show ports <portlist> {description}
Description
This command is used to display the current configuration of a
range of ports.
Parameters
<portlist> − Specifies a range of ports to be displayed. The port
list is specified by listing the lowest switch number and the
beginning port number on that switch, separated by a colon. Then
the highest switch number, and the highest port number of the
range (also separated by a colon) are specified. The beginning
and end of the port list range are separated by a dash. For
example, 1:3 specifies switch number 1, port 3. 2:4 specifies
switch number 2, port 4. 1:3-2:4 specifies all of the ports between
26