D-Link DXS-3326GSR - Page 346

DXS-3326GSR Stackable Gigabit Layer 3 Switch
show route preference
Syntax
show route preference {[local | static | rip | ospfIntra | ospfInter |
ospfExt1 | ospfExt2]}
This command will display the Route Preference Settings table. The
user may view all route preference settings by entering the
command without any parameters or choose a specific type by
adding the route parameter to the command.
local – Enter this parameter if you wish to view the route preference
settings for the local route.
static - Enter this parameter if you wish to view the route preference
settings for the static route.
rip - Enter this parameter if you wish to view the route preference
settings for the RIP route.
ospfIntra - Enter this parameter if you wish to view the route
preference settings for the Ospf Intra route.
ospfInter - Enter this parameter if you wish to view the route
preference settings for the OSPF Inter route.
ospfExtT1 - Enter this parameter if you wish to view the route
preference settings for the OSPF ExtT1 route.
ospfExtT2 - Enter this parameter if you wish to view the route
preference settings for the OSPF ExtT2 route.
Entering this command with no parameters will display the route
preference for all routes.
Restrictions None.
Description
Parameters
Example usage:
To view the route preference values for all routes:
DXS-3326GSR:4# show route preference
Command: show route preference
Route Preference Settings
Route Type Preference
---------- ----------
RIP 100
OSPF Intra 80
STATIC 60
LOCAL 0
OSPF Inter 90
OSPF ExtT1 110
OSPF ExtT2 115
DXS-3326GSR:4#
338