D-Link DXS-3326GSR - Password Protection Configuration

DXS-3326GSR Stackable Gigabit Layer 3 Switch
config port_security ports
after the aging timer expires.
 DeleteOnReset – The locked addresses will not age out
until the Switch has been reset.
Restrictions
Only administrator-level users can issue this command.
Example usage:
To configure the port security:
DXS-3326GSR:4#config port_security ports 5:1-5:5 admin_state
enable max_learning_addr 5 lock_address_mode DeleteOnReset
Command: config port_security ports 5:1-5:5 admin_state
enable max_learning_addr 5 lock_address_mode DeleteOnReset
Success
DXS-3326GSR:4#
show port_security
Purpose
Used to display the current port security configuration.
Syntax show port_security {ports <portlist>}
Description
This command is used to display port security information of the
Switch ports. The information displayed includes port security admin
state, maximum number of learning address and lock mode.
Parameters
ports <portlist> − Specifies a port or range of ports to be viewed.
The port list is specified by listing the lowest switch number and the
beginning port number on that switch, separated by a colon. Then the
highest switch number, and the highest port number of the range
(also separated by a colon) are specified. The beginning and end of
the port list range are separated by a dash. For example, 1:3
specifies switch number 1, port 3. 2:4 specifies switch number 2, port
4. 1:3-2:4 specifies all of the ports between switch 1, port 3 and
switch 2, port 4 − in numerical order.
Restrictions
None.
Example usage:
To display the port security configuration:
DXS-3326GSR:4#show port_security ports 1:1-1:19
Command: show port_security ports 1:1-1:19
Port# Admin State Max. Learning Addr. Lock Address Mode
---- ----------- ------------------- -----------------
1:1 Disabled 1 DeleteOnReset
1:2 Disabled 1 DeleteOnReset
30