D-Link DXS-3326GSR - Page 67

DXS-3326GSR Stackable Gigabit Layer 3 Switch
show firmware information
Description This command is used to display the firmware currently set in the
Switch’s memory. This Switch allows the user to hold two firmware
versions in its memory, labeled as image_id 1 and 2.
Parameters None.
Restrictions None
Example usage:
To display the current firmware information on the Switch:
DXS-3326GSR:4#show firmware information
Command: show firmware information
Box ID Version Size(B) Update Time From User
--- -- -------- ------- ------------------- ------------------ ---------------
1 *1 3.00-B16 2360471 00000 days 00:00:00 Serial Port (PROM) Unknown
1 2 3.00-B13 1052372 00000 days 00:00:56 10.53.13.94 Anonymous
'*' means boot up section
(R) means firmware update thru SerialPort (RS232)
(T) means firmware update thru TELNET
(S) means firmware update thru SNMP
(W) means firmware update thru WEB
(SIM) means firmware update thru Single IP Management
DXS-3326GSR:4#
upload
Purpose Used to upload the current switch settings or the Switch history
log to a TFTP server.
Syntax
upload [cfg_toTFTP <ipaddr> <path_filename 64> |
log_toTFTP <ipaddr> <path_filename 64>]
Description This command is used to upload either the Switch’s current
settings or the Switch’s history log to a TFTP server.
Parameters
cfg_toTFTP − Specifies that the Switch’s current settings will be
uploaded to the TFTP server.
log_toTFTP − Specifies that the Switch’s current log will be
uploaded to the TFTP server.
<ipaddr> − The IP address of the TFTP server. The TFTP server
must be on the same IP subnet as the Switch.
59