DXS-3326GSR Stackable Gigabit Layer 3 Switch
create syslog host
local5 − Specifies that local use 5 messages will be sent to the
remote host. This corresponds to number 21 from the list above.
local6 − Specifies that local use 6 messages will be sent to the
remote host. This corresponds to number 22 from the list above.
local7 − Specifies that local use 7 messages will be sent to the
remote host. This corresponds to number 23 from the list above.
udp_port <int> − Specifies the UDP port number that the syslog
protocol will use to send messages to the remote host.
ipaddress <ipaddr> − Specifies the IP address of the remote host
where syslog messages will be sent.
state [enable | disable] − Allows the sending of syslog messages
to the remote host, specified above, to be enabled and disabled.
Restrictions Only administrator-level users can issue this command.
Example usage:
To create syslog host:
DXS-3326GSR:4#create syslog host 1 severity all facility local0
ipaddress 10.53.13.94 state enable
Command: create syslog host 1 severity all facility local0
ipaddress 10.53.13.94 state enable
Success.
DXS-3326GSR:4#
config syslog host
Purpose Used to configure the syslog protocol to send system log data to a
remote host.
Syntax
config syslog host <index 1-4> [severity [informational |
warning | all] | facility [local0 | local1 | local2 | local3 | local4 |
local5 | local6 | local7] | udp_port<int> | ipaddress <ipaddr> |
state [enable | disable]]
Description
The config syslog host command is used to configure the syslog
protocol to send system log information to a remote host.
Parameters
<index 1-4> − Specifies that the command will be applied to an
index of hosts. There are four available indexes, numbered 1
through 4.
severity − Severity level indicator. These are described in the
following:
Bold font indicates that the corresponding severity level is
currently supported on the Switch.
71
To Next Page
Loading...
